3-Way Hose Fitting "Y" 1-1/8" for Bilge Hose

For use with 3" ducting. Output: 105 cubic meters per minute. Designed for flexible mounting. Simple slip-on inlet ducting connection. Corrosion-resistant. 12 volts DC.

For Jabsco pumps. Three per bag.

Use for engine cooling, wash down, circulation, and general purposes on-board or dockside Self-priming with ability to operate in either direction at variable speeds Removable end cover for easy impeller service 83 GPM - 2" NIPT - 1" diameter shaft Weight: 21 lbs

iL500 Plus pump. Suitable for diesel, salt or fresh water. Rated for 500 gallons per hour. Includes: - Pump - Spray nozzle - 4 meter cable with battery clips - 4 meter lay-flat hose. 3/4" ports. 12 volts.

Use for engine cooling, wash down, circulation, and general purposes on-board or dockside Pedestal mount, corrosion resistant bronze pumps Self-priming and portable, very versatile Removable end cover allows easy impeller service Pump heads are built of bronze materials 62 GPM, 1-1/4" NIPT Port, 1" shaft, face seal, brass cam and impeller insert Weight: 12.6 lbs

For use with 1 to 5 gallon accumulator tank. Designed for 6 or more fixtures. Quiet, smooth flow. Not harmed if it runs dry. Strainer included. Plug-in ports, easy to install. May be attached to garden hose or 3/4" hose barbs.

Can deliver almost 7 GPM at open flow. Equipped with pressure-cast bronze body. Features a reusable O-ring type end cover seal. 1/2" internal pipe thread and 1" external hose barb. Includes 2 port adapter. 12 volt DC. Weight: 6.06 lbs

Oil resistant nitrile impeller or 6050 and 6850 Weight: .495 lb

High pressure switch. Rated for pressure between 20 and 40 psi. Used with Jabsco model 44010-2000 and others.

For use with 4" ducting. Output: 250 cubic meters per minute. For use in engine rooms, galleys or heads. Flange designed to mount directly to bulkhead. Corrosion-resistant.

Provides high pumping capacity and reliability.
All-in-one pump and intelligent switch.
Designed to activate at 2-1/2" deep water.
Circuit will automatically cycle when needed.
1" and 1-1/8" discharge outlets.
12 volts DC.

Replaceable wear plate to extend service when handling abrasive fluids
9.5 GPM - 115 Volt Motor - 1/3 HP - 1/2" NIPT
Dimensions: 7-3/4"H x 7-1/4"W x 10-1/2"L

Jabsco 50890 waste pump. A single-diaphragm, 5 GPM plastic-body pump. This self-priming pump is designed to pass debris. No filter required. OK to run dry and equipped with a 360º rotatable head. 12 volt.

Traditional styling.
Has a combined flush / waste pump.
Compact bowl.
12 volt.
3/4" inlet hose, 1" discharge hose.

Prevents particles from entering pump. Cuts down on repairs, easy to install. Transparent housing for quick inspection. 50 mesh stainless steel filter screen. 3/4" hose barb ports, one bottom port for 90° installations.

Equipped with a Viton O-ring. Quad port X 1" hose barb connector. Two per package.

Prevents particles from entering pump. Cuts down on repairs, easy to install. Transparent housing for quick inspection. 50 mesh stainless steel filter screen. Slip-on 1/2" ports.

Quick, easy and clean oil changes at flip of a switch Removes oil/sludge through dip stick tube so engine oil changes quick and easy. No spill under engine. Oil changer supplied with both 1/4" x 40" dipstick probe and a female garden hose connector that attaches suction hose directly to dipstick tubes supplied with male garden hose threads. Reversible pump so container is emptied neatly/easily by reversing flow direction. Retractable pouring spout if not desirable to use pump for emptying. 12 volt model with 8' cord and alligator clips. Simply connect power cord to appropriate electrical source. With flick of switch sturdy motor pump unit drains crankcase into its 14 qt. holding container. Dimensions: Height 13-5/8", Width 13-1/2" 
 

Neoprene. 12 blades. Diameter: 2-1/4".

Nitrile. 12 blades. Diameter: 2-1/4".

Neoprene. 10 blades. Diameter: 2-9/16".

Designed to remove water from basements, garages, stairwells, utility rooms, back yards, sumps, pools, pool covers, boats and more.
Fully-automatic version uses standard 110 volt AC current
8' cord.
1800 GPH.

Brass construction. For Jabsco pumps repairs.

T-Handle pump for 29090 toilet Weight: 1.85 lb

A lighter, compact pump for smaller vessels.
Tough plastic body with integral strainer.
Quick-release inlet strainer allows for quick cleaning.

12 volt DC.
3/4" hose connections.
Output: up to 23 liters per minute.

Includes a Rule 35A non-mercury float switch.

A compact, general-purpose pump. Bronze body. Nitrile impeller. 3/8" ports. Rated for 3.4 gallons per minute at 10 feet. Stainless steel shaft. 6 foot cord, with AC plug.

"FC" Tournament series pump.
Rated for 1100 gallons per hour.
Features removable motor cartridge.
1-1/8" ports.
12 volts.

For use with 1 to 5 gallon accumulator tank Designed for 6 or more fixtures Quiet smooth flow No harm if runs dry. Strainer included. Plug-in ports, easy install: 2 for garden hose and 2 for 3/4" hose barb. Weight: 6 lbs

Electromagnetic clutch pumps equipped with a powerful electric clutch for convenient remote operation 12 volt pump Capable of operating through a wide range of speeds and in either rotational direction. Dimensions: 2A Pulley Belt Grooves - 2" NIPT - 83 GPM Weight: 30.5 lbs

For pumps: 4305, 4405 and 4325. Weight: .4 lb

Brass construction. For 11860.